Electrical Engineering
Graduate Courses and Projects
- Advanced Analog Integrated Circuit Design II
- Designed a current reference based on band-gap voltage reference in 0.18 μm CMOS
- Advanced Analog Integrated Circuit Design I
- RF and High-Speed Integrated Circuits
- Designed a 40 GHz PLL (40 GHz VCO + 1/16 divider + phase comparator) in 90 nm CMOS
- Designed a 17 GHz fully-differential tuned LNA with 2.5 V power supply in SiGe200/sbc18 HBT
- Advanced Topics in Analog Circuits
- Designed an on-chip linear voltage regulator in 0.35 μm CMOS with minimum PSRR of 20 dB over all frequencies
- Designed a switched-capacitor gain of 2 and a second-order low-pass filter
- System-level and circuit design of a 12-bit second-order delta-sigma A/D with OSR of 20 and
layout of telescopic op amps with four gain-boosters in 0.18 μm CMOS
- VLSI Design Methodology
- Design and layout of a 256 kb DRAM (complete chip) with less than 2x2 mm area in 0.35 μm CMOS
- Designed a 4-bit unsigned array multiplier in 0.35 μm CMOS
- Analog Circuit Design I
- Designed a fully-differential two-stage op amp in 0.35 μm CMOS
- Analysis and simulation of a frequency synthesizer and circuit design of a 1.5 GHz VCO in 0.35 μm CMOS
- Data Commuication
- Data Networks
- Studied data networks topology generation methods
- Digital Image Processing
- Camera calibration using pin-hole model
- 3D reconstruction from stereo images
- Digital Signal Processing
- Designed an FIR linear prediction filter for Dow Jones Industrial Average weekly data
Teaching Experience
- Teaching assistant for Signals and Systems, Sharif University of Technology, fall 2002.